Thermo Proof Plus Sun spacer mounting system

- Application: Insulation up to 220 mm
- Application: Fastening of awnings, canopies, satellite dishes, etc.
- Stainless steel A4: For indoor and outdoor applications with direct weathering.
- Loadable up to 1,380 kg
- Approved by the building authorities
- Secure protection against energy loss and thermal bridges
- Only fastening system for French balconies with M10 connection

Contents:
- Insulating sleeve Iso Spacer: 2 x pieces
- Threaded rod M16 x 300 mm, A4: 2 x pieces
- Screw M10 x 40 mm, A4: 2 x pieces
- Screw M12 x 40 mm, A4: 2 x pieces
- Sieve sleeve Liquix Sleeve 20 x 85 mm: 2 x pieces
- Extension tube 10 x 200 mm for static mixer: 1 x piece
- Special sealant Aqua-Stop 80 ml: 1 x piece

Installation:
1. Drill through thermal insulation (ø 30 mm)
2. Measure thermal insulation
3. Drill a hole in the building material and remove the plaster layer if necessary.
4. Clean borehole
5. If necessary, shorten the threaded rods (length = drill hole depth + insulation layer) and screw on the Iso Spacer.
6. In perforated brick only with sieve sleeve. Insert this completely into the borehole
7. Fill 2/3 of the borehole in the subsoil or the sieve sleeve completely with composite mortar.
8. Insert the threaded rod with the pre-mounted Iso Spacer into the drill hole with a slight twisting movement.
9. Allow composite mortar to cure
10. Seal gap with silicone
11 Fitting the attachment