Jung heating actuator with thermostat 6-way KNX REG 2336REGHZRHE

• Division units: 4
• Nominal voltage: AC 110-230 V ~, 50/60 Hz
• Nominal voltage KNX: DC21-32 V SELV
Heating outputs:
• Switching voltage: AC 24 / 230 V ~
• Switching current: 5-160 mA
• 6 “Triac” outputs
• Integrated room temperature control with setpoints

• Standby power: max. 0.4 W
• Power loss: max. 1 W
• Power consumption KNX: max. 250 mW
• Ambient temperature: -5 to +45°C
Heating outputs:
• Contact type: Semi-conductor (Triac), ε
• Mains frequency: 50/60 Hz
• Switching current: max. 1.5 A (2 s)
• Switching current: max. 0.3 A (2 min)
• Number of actuators per output:
- 230 V actuators: max. 4
- 24 V actuators: max. 2
• Connection of outputs: screw terminals
- Single wire: 1 x 0.5 ... 4 mm²
- Fine wire without ferrule: 1 x 0.5 ... 4 mm², 1 x 0.5 ... 4 mm² , 1 x 0.5 ... 2.5 mm²
• With electronic manual actuation and LED status display
• Switching of electrothermal actuators for heating systems (e.g. TSA 230 NC WW, TSA 24 NC WW) or cooling ceilings
Product features:
• Six independent controllers for controlling for up to six independent frame
• Controller function for heating and cooling operation
• Actuators with the characteristics normally open or normally closed can be operated
• 230 V or 24 V actuators can be operated
• Outputs can be controlled manually, building site operation
• Feedback in manual and bus mode
• Blocking of individual outputs by hand or bus
• Overload protected, short circuit protected
• Error display with LED
• Protection against jammed valves
• Forced position
• Different default values can be set for override or emergency operation in the event of bus failure in summer and winter
• Cyclical monitoring of the input signals can be parameterised
• Feedback via bus, e.g. on overload, mains or sensor failure