GIRA switch actuator 2-way 16A with manual actuation KNX REG

• Contact: 1 NO contact each, floating, flip-flop
• Switching capacity:
- AC 230 V: 16 A / AC1 or 10 A / AC3
- AC 400 V: 10 A / AC1 or 6 A / AC3
- DC: 16 A / 24 V
• For switching independently controllable load groups

• KNX: connection and junction terminal
• Load: screw terminals
• Relay
• Max. switching current: 400 A, 150 µs, 200 A, 600 µs
• Connected load
• Ohmic load: 3600 W
• Capacitive load AC 230 V: 16 A, max. 140 µF
• Bulbs: 2500 W
• HV halogen: 2500 W
• Coiled transformer: 1200 VA
• Tronic transformer: 1500 W
• Fluorescent lamps:
- Uncompensated: 2500 VA
- Duo circuit: 2300 VA
- Parallel-compensated: 1300 VA
• Mercury vapour lamps:
- Uncompensated: 2000 W
- Parallel-compensated: 2000 W
• Connection cross-section: max. 4 mm²
• Integrated bus coupling
• Manual switch for operating the relay (on/off) in parallel or without KNX operation
• Multiphase connection
• No additional power supply required
• Manual actuation of the relay independently of the bus or switch position display
• NO and NC contact operation
• Central switching function
• Group feedback for reduction of bus load
• Active or passive (object can be read) cyclical feedback functions
• Feedback can be delayed until after recovery of bus voltage
• Logical connection function for each output
• Block function can be parameterised for each channel. As an alternative, forced setting function for each output.
• Time functions (switch-on/off delay, staircase light function – also with advance warning function)
• Integration into scenes is possible, a maximum of eight internal scenes can be configured per channel
• Memory function for light scenes
• Operating hors counter as forward/backward counter with limit function (limit can be changed via bus) can be activated for each output.
• Input monitoring for cyclical updating with safety setting
• Reactions in case of bus voltage failure and restoration can be set for each channel following an ETS programming process
• Independent switching of the outputs
• Connection and junction terminal for KNX supplied
• VDE approval in accordance with EN 60669-1, EN 60669-2-1